Cypress 7C185-20 Betriebsanweisung PDF herunterladen (Seite 2)

Cedar 880AG Dual-Radio AP/Bridge

This product and documentation are protected by copyright. No part of this product or

document may be reproduced, transmitted, transcribed and stored in a retrieval system in

any form or by any means without prior written authorization of Intelicis.

Third Party Copyright Acknowledgements

Please refer to the license.pdf on the CD distributed with the Cedar8880AG Enterprise

Dual-Radio Access Point for complete third party copyright acknowledgements.

United States 802.11a 5250 Mhz ~ 5350 MHz Usage Note:

Due to US DFS requirement, the 802.11a radio frequency usage from 5250 Mhz to 5350

MHz is temporarily disabled for US model. This band will be enabled in the future

through firmware upgrade after the product has finished and passed DFS test.

FCC Compliance

This equipment has been tested and found to be in compliance with the limits for FCC

Part 15, Class B digital device. These limits are designed to provide reasonable protection

against harmful interference when the equipment is operated in a commercial

environment. This equipment generates, uses and can radiate radio frequency energy and,

if not installed and used in accordance with instruction manual, may cause harmful

interference with radio communications. Operation of this equipment in a residential area

is likely to cause harmful interference in which case the user will be required to correct

the interference at his own expense.

The users are prohibited from making any change or modification to this product, any

modification to this product shall void the user’s authority to operate under FCC Part 15

Subpart A Section 15.21 regulations.

“This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference and, (2)

this device must accept any interference received, including interference that may cause

undesired operation.

Caution

Reader should be positioned so that personnel in the area for prolonged periods may

safely remain at least 20 cm in an uncontrolled environment from the reader’s surface.

Observe FCC OET Bulletin 56 “Hazards of radio frequency and electromagnetic fields”

and Bulletin 65 “Human exposure to radio frequency electromagnetic fields.”

Frequency Stability Statement

A carefully chosen AT-cut crystal resonator that offers tight frequency tolerance and

stability over operating temperature is used in this device so that frequency stability of

this device is ensured to be within +/- 15 ppm that an emission is maintained within the

1 2 3 4 5 6 7 ... 108 109

Keine Kommentare

Cypress 7C185-20 Betriebsanweisung Seite 2