Cypress Chameleon CTM-15X Bedienungsanleitung PDF herunterladen (Seite 13)

13 Example Modem PAD Configuration

Enter the following commands from the serial console of the modem connected to the serial master

device:

cmd factory

cmd mode 2

cmd port 19200 8 n 1 2

It will now be necessary to adjust the baud rate of the terminal application to 19200.

cmd padmode 2/3 PAD client, single-session mode: 2 = UDP, 3 = TCP

cmd padecho 1 Echo data sent by the master device back on the serial port

(default setting, in effect after cmd factory)

cmd padfwdc 0 No forwarding character

cmd padfwdl 101 Greater than longest message size

cmd padfwdt 100 Sets the forwarding time to 5 seconds idle period

cmd padsvct 10 0 Set connection timeout to 10 seconds, maximum connection timer disabled

cmd save Save configuration to modem’s non-volatile memory

cmd pwrmode 2 Power cycle

In command mode, for each request to a specific slave device, the master device should send the

following commands:

cmd padip 100.100.1.1 Sent by master device to set new PAD slave to which to connect

cmd pad Sent by master device to start new PAD connection

Upon executing cmd pad, the modem will connect to the PAD slave with IP address 100.100.1.1 as

specified in cmd padip, transmit a request, and disconnect if the connection idle time is 10 s, or if the

escape sequence is entered on the serial port (default is +++). Once disconnected, the modem will drop

into command mode. Repeat cmd padip and cmd pad for other slave devices using IP addresses

100.100.1.2-100.100.1.10.

1 2 ... 8 9 10 11 12 13 14 15

Keine Kommentare

Cypress Chameleon CTM-15X Bedienungsanleitung Seite 13